Locating The Heater - Heat & Glo 6000TRSI-AUC Installation And Operation Instructions Manual

A. Locating the Heater
The diagram (see Figure 1.2) shows space and clearance requirements for locating a heater within a room.
Rear Flue
1"MIN. (25mm)
A
A B
Inches 42 22
Millimeters 1066 559
FIGURE 1.2 Heater Dimensions, Locations and Space Requirements
Minimum Clearances from the Heater to
Glass
Front Floor
36 inches 0
(914 mm)
Clearance Requirements
The top, back, and sides of the heater are defined by standoffs.
The minimum clearance to a perpendicular wall extending past the face of the heater
is one inch (25 mm).
For 6000 Series Models, the back of the heater may be recessed 21-1/2 inches (546
mm) into combustible construction.
Minimum Clearances from the Flue Pipe to Combustible Materials
For Horizontal Sections
Top Bottom
3 inches 1 inch
(75mm) (25mm)
For minimum clearances, see the direct flue termination clearance diagrams on page 7.
B
E
D
C
3" (76.2mm)
C D E
38 53-3/4 76
965 1365 1930
Combustible Materials
Back of Sides of
Heater Heater
1/2 inch 1/2 inch
(13 mm) (13 mm)
For Vertical
Sections
Sides
1 inch
(25mm)
Heat & Glo • 6000TRSI-AUC • 2078-900 Rev. C • 7/06
Top Flue
1" MIN. (25mm)
A
Inches 42
Millimeters 1066
Top of
Heater Ceiling
3-1/2 inches 31 inches
(89 mm) (787 mm)
Top
1 inch
2-1/2 inches
(25mm)
(63.7mm)
B
E
C
1/2" MIN. (12.5mm)
B C D E
22 36 50-15/16 72
559 914 1294 1829
At Wall Firestops
Bottom Sides
1/2 inch 1 inch
(13mm) (25mm)
D
5