Heat & Glo 6000TRSI-AUC Installation And Operation Instructions Manual page 15

WARNING: ENSURE THAT THE HEATER GASKET
SUPPLIED WITH THE HEATER SEALS BETWEEN
THE FIRST FLUE COMPONENT AND THE OUTER
HEATER WRAP.
WARNING
Fire Risk
Exhaust Fumes Risk
Impaired Performance of Appliance
• Overlap pipe slip sections at
least 1-1/2 inches (38.1mm).
• Use pilot holes for screws.
• Screws must not exceed one inch
long.
• Pipe may separate if not properly
joined.
2. Assembling Flue Components
Insert the inner flue of section A into the flared inner
flue of section B.
Start the outer flue of section A over the outer flue of
section B (see Figure 1.18). Note: The end of the pipe
sections with the lances/tabs on it will face towards
the appliance.
Once both inner and outer flues are started, press sec-
tion A onto section B firmly until all lances have
snapped into place. Check to make sure they have
snapped together (see Figure 1.19) and the seams
are not aligned (see Figure 1.20). Tug slightly on sec-
tion A to confirm it has completely locked into place.
A
B
Figure 1.18 Figure 1.19
Heat & Glo • 6000TRSI-AUC • 2078-900 Rev. C • 7/06
CORRECT
INCORRECT
Note:
Make sure that the seams are not aligned to
prevent unintentional disconnection.
Figure 1.20 Seams
NOTE: Make sure that seams are NOT aligned to
prevent unintentional disconnection.
For elbows that are changing the flue direction, two
screws minimum should be put in the outer flue at
the joint to prevent the elbow from rotating.
15