Heat & Glo 6000TRSI-AUC Installation And Operation Instructions Manual page 2

PLEASE READ THIS MANUAL BEFORE INSTALLING AND
MODEL 6000TRSI-AUC
IS AUSTRALIAN GAS ASSOCIATION
APPROVED FOR NATURAL GAS OR
PROPANE AS A BALANCED FLUE HEATER.
Refer to the appliance data plates for gas con-
sumptions and pressures.
Installation of this appliance should only be car-
ried out by an authorized person in accordance
with the manufacturers instructions. All relevant
codes and regulations laid down by the gas fitting
authorities, municipal building regulations, electri-
cal wiring regulations, and the requirements of the
AGA Gas Installation Code must be observed.
This appliance and its components are tested and
safe when installed in accordance with this Instal-
lation Manual. Report to your dealer any parts dam-
aged in shipment, specifically check glass condi-
tion. The gas logs and flue system components
are in separate packages. Read all instructions be-
IMPORTANT: Read all instructions carefully before starting installation.
Failure to follow these installation instructions may result in a possible
fire hazard and will void the warranty. Save this manual for future refer-
ence.
Heat & Glo, a brand of Hearth & Home Technologies, Inc.
20802 Kensington Blvd., Lakeville, MN 55044, USA
Copyright 2006 • Printed in U.S.A.
2
USING THIS APPLIANCE.
Heat & Glo • 6000TRSI-AUC • 2078-900 Rev.C • 7/06
fore starting installation and follow these instruc-
tions carefully during installation to ensure maxi-
mum benefit and safety. Failure to follow them will
void your warranty and may present a fire hazard.
The Heat & Glo warranty will be voided by, and
Heat & Glo disclaims any responsibility for the fol-
lowing actions:
• Installation of any damaged heater or flue sys-
tem component
• Modification of the heater or balanced flue
system installation other than as instructed by
Heat & Glo.
• Improper positioning of the gas logs or the
glass door
• Installation and/or use of any component part
not manufactured or approved by Heat & Glo,
not withstanding any independent testing
laboratory or other party approval of such
component part or accessory.
Heat & Glo Quality Systems
registered by SGS ICS