Arming Stay: Praotecting Yourself At Home - NAPCO GEM-K1VPS Operating Manual

A R M I N G S T A Y : P R O T E C T I N G Y O U R S E L F AT H O M E
Arming in the Stay mode allows you to remain home with the perimeter protection active but with the interior protection off,
so that you may move freely within the premises.
1 Check the keypad.
SYSTEM READY
"SYSTEM READY", indicating that the system is ready to arm.
2
Enter your code and press P*.
The keypad will voice prompt the correct action.
3
The LCD window will read "ARMING STAY" during the exit delay time period. The remaining exit delay
4 After the exit delay time period, the entry doors are protected and will initiate the entry delay se-
quence if opened.
Note: For additional security, the system can be placed in "Instant Mode" by pressing and holding
The green STATUS light must be ON-STEADY, and the LCD window will read
• If the green light is off, "ZONES FAULTED" will display in the window followed by the number and
description of each faulted zone. Note each problem zone and secure it by closing a window, door,
etc. When all zones are secure, the green STATUS light will turn on and the LCD window will display
"SYSTEM READY". If you cannot immediately secure the zones, they may be bypassed (see page 14).
time (in seconds) is also displayed.
for 2 seconds. This removes the entry delay, causing the system to go into alarm immedi-
P
ately (without entry delay) when the door is opened. This mode will be indicated by the rapidly
flashing ARMED LED. To disarm, see page 18.
*If Easy Arm feature is enabled, there is no need to enter your code--just press and hold the P button.
"System is arming
in Stay mode.
If leaving, please
exit now."
9