Chaptor 4 Troubleshooting - LevelOne WAP-6101 User Manual

WPA-6101 300Mbps Wireless Ceiling Gigabit PoE Access Point

CHAPTOR 4 Troubleshooting

This Chapter provides solutions to problems for the installation and operation of the WiFi
Concurrent N300 Business AP. You can refer to the following if you are having problems.
1 Why can't I configure the device even the cable is plugged
and the LED is lit?
Do a Ping test to make sure that the WiFi
Access Point is responding.
Go to Start > Run.
1. Type cmd.
2. Press OK.
3. Type ipconfig to get the IP of default gateway.
Type "ping 192.168.1.50". Assure that you ping the correct IP Address
4.
assigned to the WiFi Concurrent N300 Business AP. It will show four replies if
you ping correctly.
Ensure that your Ethernet Adapter is working, and that all network drivers are installed
properly. Network adapter names will vary depending on your specific adapter. The
Note: It is recommended that you
use an
Ethernet
configure it
connection to