Use Wec Button To Setup Wireless Profiles - LevelOne WAP-6101 User Manual

WPA-6101 300Mbps Wireless Ceiling Gigabit PoE Access Point
2.2

Use WEC Button to Setup Wireless Profiles

WEC Button is Wireless Easy Connection. There are 2 purposes for this Button.
One is to switch AP into Master or Slave Mode.
However, Main purpose of Slave AP is to get Wireless profile of Master AP to extend
connective distance w/o login configured Web.
Access Point is in Master Mode
Generally speaking, the settings of Master AP can work in your Network environment.
When System is ready: (without click button.) Status LED in Solid : In Master Mode
※Device Network IP Address depend as current Settings.
Access Point is in Slave Mode
New deployed or reset-to-default Access points have to configure Wireless setting so
that can work current network environment.
When System is ready: (without click button.) Status LED in Flash: In Slave Mode
※Device Network IP Address is DHCP Client in Slave Mode.
Please check if DHCP Server exists in your Network Environment.
If Not, please change to Master Mode after getting Wireless Profiles, it will be Default IP
"Static IP".(Due to New deployed or reset-to-default Access point.)