Table of Contents
Advertisement
APPENDIX A: TROUBLESHOOTING
This chapter provides solutions to frequently encountered problems that can occur during the
installation and operation of LevelOne 54Mbps Wireless Access Point. Please read through the
following to solve your problems.
1.
The computer connected to LevelOne Wireless Access Point through Ethernet
network cannot access the configuration menu.
♦ Check that the Ethernet Adapter is working properly. Make sure that the drivers for
the network adapters are installed properly.
♦ Check that the Ethernet cable is connect to the Wireless Access Point properly, and the
Ethernet LED of the Wireless Access P oint is ON.
♦ Check that the IP address of the computer is in the same IP range and subnet as that
o f the Wireless Access Point. Please refer to the Networking Basis in APPENDIX B in
this manual for more information if necessary.
NOTE:
The default IP Address of LevelOne Wireless Access Point is 192.168.1.1. All the computers on
the network must have a unique IP address in the same range, e.g., 192.168.1.xxx, and they
must all have the same subnet mask, e.g., 255.255.255.0.
♦ Check the connection of computer a nd Wireless Access Point by doing a simple Ping
test.
♦ Go to Start>Run>Type "command"> Type "ping 192.168.1.1 ". A successful ping will
show responses from the Wireless Access Point.
-38-
Advertisement
Table of Contents
