Table of Contents
Advertisement
CHAPTOR 4 Troubleshooting
This Chapter provides solutions to problems for the installation and operation of the WiFi
Concurrent 300Mbps Business AP. You can refer to the following if you are having
problems.
1 Why can‟t I configure the device even the cable is plugged
and the LED is lit?
Do a Ping test to make sure that the WiFi
Access Point is responding.
Go to Start > Run.
1.
Type cmd.
2.
Press OK.
3.
Type ipconfig to get the IP of default gateway.
Type "ping 192.168.1.1". Assure that you ping the correct IP Address
4.
assigned to the WiFi Concurrent 300Mbps Business AP. It will show four
replies if you ping correctly.
Ensure that your Ethernet Adapter is working, and that all network drivers are installed
properly. Network adapter names will vary depending on your specific adapter. The
Note: It is recommended that you
use
an
Ethernet
configure it
connection
to
Advertisement
Table of Contents
