Normal Operation - Takagi 710 Installation Manual And Owner's Manual

NORMAL OPERATION

 Flow rate to activate the 710 (T-M32)
 Flow rate to keep the 710 (T-M32) running : 0.4 gallon per minute
1. Open a hot water tap.*
*If a remote controller installed, turn the remote controller ON by pressing the power ON/OFF button on the remote
controller and then set the temperature by pressing the HOT/COLD buttons before opening a hot water tap. The
temperature is displayed when the remote controller is turned ON.
WITH REMOTE CONTROLLER INSTALLED: 9007603005 (TM-RE30) (Optional)
1. Press the power ON/OFF button.
Temperatures available under the Default Mode
100 105 110 115
Temperatures available under the High Temperature Mode
110 115 120 125
DO NOT set to 185°F if you use your water heater in recirculation system. Refer to p.34
3. Open a hot water tap.
Mix cold water with the hot if you need.
Hot Water temperatures over 125F (52ºC) can cause severe burns instantly or death from
scalding.
 The outlet hot water temperature of the water heater is factory set at 120F (49ºC).
 Feel the water temperature before bathing or showering.
1. NORMAL OPERATION
WITHOUT REMOTE CONTROLLER
2. Mix cold water with the hot to get
the correct temperature water.
2. NORMAL OPERATION
When ON,
green LED is lit.
The temperature and the
time will be displayed on
the remote controller.
120 125 130
130 135 140
Lamp is ON
Lamp is ON
WARNING
: 0.5 gallon per minute
2. Set temperature. (Example 110°F)
135 140 145 150
145 150 155 160
4. Close the hot water tap.
- 31 -
3. Close the hot water tap.
155 160 165 170
165 170 175 180
Lamp is OFF
Lamp is OFF
175
185
(unit:°F)