Takagi 710 Installation Manual And Owner's Manual page 37

PROBLEM
Unit does not ignite when water goes
through the unit.
The fan motor is still spinning after
operation has stopped.
Abnormal sounds come from the unit.
~ REMOTE CONTROLLER: 9007603005
PROBLEM
Remote controller does not display
anything when the power button is
turned on.
An ERROR code is displayed.
PROBLEM
How are the unit numbers assigned?
~ WATER HEATER ~
 Is the flow rate over 0.5 GPM? (p. 31)
 Check for the filter on cold water inlet. (p. 35)
 Check for reverse connection and cross connection.
 If you use the remote controller, is the power button
turned on? (p. 31)
 This is normal. After operation has stopped, the fan
motor keeps running for 35 seconds in order to re-
ignite quickly, as well as push all exhaust gas out of
the flue.
 Contact the manufacturer at 1-877-737-2840.
(TM-RE30) (OPTIONAL) ~
Press the ON/OFF button.
If the lamp lights up ⇒
 This is normal. When the unit has not operated for
five minutes or more, the display turns off to
converse energy.
If the lamp does not light ⇒
 Make sure the unit has power supply.
 Make sure the connection to the unit is correct.(p. 20)
 Please see the p. 38.
~ EASY-LINK SYSTEM ~
 For an Easy-Link system, other than the Parent unit
(which is always labeled #1), all the other units (the
Child units) are numbered randomly.
 To check which numbers are assigned to which
units, push the button on the computer board of a
unit as shown below.
displayed on the 7-Seg LED.
Button to check
unit numbers
- 37 -
POSSIBLE SOLUTIONS
POSSIBLE SOLUTIONS
POSSIBLE SOLUTIONS
7-Seg LED
The unit number will be