Diagnostic Screens - Permobil C350 Owner's Manual

Owner´s Manual Permobil C350
R-net Diagnostics
Whenever an error on the wheelchair's control system occurs, information about
this is shown on the control panel's display. This information can be used for
diagnosing the error.
The remedying of errors that are indicated via the control panel display must be
performed by a person with sufficient expertise to be able to perform such tasks
in a professional manner. Always contact an authorized Permobil Service Center
when in doubt. More information about service and repairs is found in the chassis
service manual.

Diagnostic Screens

Current Diagnostic Screen
When the control system safety circuits have operated and the control system
has been prevented from moving the wheelchair, a diagnostics screen will be
displayed.
This indicates a system trip, i.e. the R-net has detected a problem somewhere
in the wheelchair's electrical system.
NOTE
If the error is in a non-active module, then drive will still be possible, however, the diagnostic screen
will appear intermittently.
Switch off the control system for a couple of minutes. Switch on the control sys-
tem again and try to drive the wheelchair. If the safety circuits operate again, do
not try to use the wheelchair. Write down the information shown on the display
and switch the control system off. Contact your service provider.
Don't use the wheelchair before you get it repaired, or get other instructions from
your service provider.
WARNING
The remedying of errors that are indicated via the control panel display must be performed by a
qualified service technician authorized by Permobil to perform such service on Permobil products.
Permobil Inc. is not responsible for personal injuries or damage resulting from inappropriate or
wrong performed repairs.
84
Troubleshooting Guide