Remote Lxe Keyboard Bracket Assembly - LXE VX7 User Manual

48

Remote LXE Keyboard Bracket Assembly

Equipment Needed: Phillips screwdriver, torque wrench.
1.
2.
3.
4.
Note: Bolts, washers, and wrench needed when attaching the bracket to the vehicle are not
supplied by LXE.
IMPORTANT:
VX7 User's Guide
Figure 43 Remote Keyboard Bracket Assembly
Place the keyboard face down on a flat, stable surface.
Position the bracket on the keyboard base, aligning the four screw holes in the
keyboard with the four mounting holes in the bracket flanges. When positioned
correctly, the bracket should overlap at the top of the keyboard.
Attach the keyboard to the bracket with four screws (included). Tighten to 9 +/- 1 in/lb
(1.02 N/m).
Attach the keyboard-bracket assembly to the vehicle's mounting surface using four 1/4
bolts, lock washers and flat washers or equivalent.
Mount to the most rigid surface available.
Install Mounting Brackets
1. Keyboard Cable
2. LXE Keyboard
3. Bracket
4. Mounting Surface
5. Mounting Hardware (not shown):
Screws, 8-32x5/8 (4 each) for use
with the 95-key keyboard
Screws, 10-32x5/8 (4 each) for
use with the 60-key keyboard
E-EQ-VX7OGWW-D