Setting Up The Floorstand Model - Fujitsu PRIMERGY TX150 S7 Operating Manual

Hardware installation
4.2

Setting up the floorstand model

I
If you are not installing a PRIMERGY TX150 S7 floorstand model, skip
this section and continue reading at
model" on page
Ê Transport the server to the place where you want to set it up.
Ê Unpack the server (see
Ê Set up the server.
I
Note that on floorstand models with hot-plug power supply units, for
safety reasons (risk of tipping) the anti-tilt bracket supplied must be
fitted on the rear of the server (see section
bracket" on page
V
CAUTION!
– The device must be protected from direct sunlight.
– The required minimum distances for operation and maintenance
areas must be adhered to.
– The server must be accessible at the rear for connection to other
devices (e.g. memory subsystem).
– The mains plug must be accessible easily and safely.
– There must be a clearance of at least 200 mm in front of and
behind the server to ensure adequate ventilation of the
subsystem.
Ê Wire the server. Follow the instructions in sections
the server" on page 55
page 58.
Ê Connect the server to the mains (see section
mains" on page
TX150 S7
45.
section "Unpacking the
44).
and "Notes on connecting/disconnecting cables" on
56).
Operating Manual
Setting up the floorstand model
section "Installing/removing the rack
server").
"Mounting the anti-tilt
"Connecting devices to
"Connecting the server to the
43