Assembling And Hanging The Fan - Hunter Camille Owner's Manual And Installation Manual

WARNING: Fan may fall if not assembled as directed in these
installation instructions.
You can assemble your fan for standard or angled mounting as
shown in steps below.
3-1. Unbundle the wires from the fan.
3-2. Feed the wires from the fan through the downrod.
Note: Make sure all the wires are on the same side of the metal
dowel pin inside the downrod.
3-3. Loosen the square head setscrew on the adapter in order to
install the downrod.
3-4. Insert the downrod into the adapter. Tighten by turning the
downrod assembly at least 4-5 full turns until it stops.
Note: When the downrod assembly is fully installed, 2-3 threads
on the pipe will still be visible; this is normal. Securely
retighten the setscrew with a wrench or pliers.
WARNING: If the setscrew is not tightened securely, the fan
may fall.
3-5. (Optional) - The wires can be cut (shortened), but leave at
least 8" extending from the top of the downrod.
3-6. Raise the fan and place the downrod ball into the ceiling bracket.
3 • Assembling and Hanging the Fan
8
M0022-01 • 09/10/12 • Hunter Fan Company
Setscrew
Steps 3-1 – 3-4
For angled ceilings, point
opening toward peak
Step 3-6
Downrod
Canopy
Adapter
Ceiling
Bracket
Downrod