Installing The Ceiling Bracket - Hunter Camille Owner's Manual And Installation Manual

CAUTION: To avoid possible electrical shock, before installing your fan,
disconnect the power by turning off the circuit breakers to the outlet box
and associated wall switch location. If you cannot lock the circuit breakers
in the off position, securely fasten a prominent warning device, such as a
tag, to the service panel.
2-1. Note: The ceiling bracket may be mounted to an existing ceiling-
-fan-rated outlet box. If the outlet box is not ceiling-fan-rated,
drill two pilot holes into the wood support structure.
The pilot holes should be 9/64" in diameter and through the
outermost holes in the outlet box.
2-2. Your fan comes with four neoprene noise isolators. Position the
isolators between the ceiling bracket and the ceiling by inserting
the raised areas on each isolator into the holes in the ceiling
bracket.
2-3. Align the slotted holes in the ceiling bracket with the pilot holes
you drilled in the wood support structure. Note: The isolators
should be flush against the ceiling.
2-4. Place a flat washer on each of the two 3" wood screws and pass
the screws through the slotted holes in the ceiling bracket into the
pilot holes you drilled.
2-5. Tighten the screws into the 9/64" pilot holes; do not use lubricants
on the screws. Do not over tighten.
2 • Installing the Ceiling Bracket
Flat Washer
M0022-01 • 09/10/12 • Hunter Fan Company
Isolator
Ceiling
Bracket
3" Wood
Screw
7
Step 2-2
Steps 2-3 – 2-5