Hunter TYPE 3 Installation Instructions Manual page 6

Step 10: Install Globe
A.
Install the glass globe assembly to fixture fitter. See Figure 10.
Inside the top of the globe assembly locate the (3) plastic clips.
See Figure 10A. The clips have a horizontal flange which is used
to support the globe assembly during installation.
VIEW LOOKING DOWN INTO GLOBE ASSEMBLY
Figure 10A
After you've located the (3) plastic clips inside the globe, locate the
(3) matching clearance openings in the bottom of the fixture fitter.
Lift the globe assembly and position the (3) plastic clips inside the
clearance holes in the fitter. See Figure 10B.
NOTE: You can easily align the plastic clips with the clearance
openings by looking through the space between the housing and
globe assembly as you lift the globe assembly into position.
GLOBE
ASSEMBLY
LIFT GLOBE ASSEMBLY AND ROTATE
Figure 10B
Lift the globe assembly until it's free to rotate in either direction.
Rotate the globe assembly until the (3) screw clearance holes in
the globe trim line up with the matching threaded holes in the
fixture fitter. See Figures 10 and 10C.
41228-01 12/95
FIXTURE FITTER
GLOBE ASSEMBLY
Figure 10
PLASTIC CLIP
FIXTURE FITTER
CLEARANCE
HOLES
PLASTIC CLIP
Secure the globe assembly to the fitter using (3) decorative
screws found in sack parts. See Figure 10C.
Tighten all (3) assembly screws.
CAUTION: Failure to securely tighten the (3) assembly screws
could result in the globe assembly falling.
Step 11: Operation of Remote Control
Operating Instructions: The hand-held transmitter has individ-
ual buttons for control of the light, for controlling the fan speeds,
for turning the fan off, and .for reversing. See Figure 11.
NOTE: Be sure to install a fresh battery. Check for weak battery
if fan fails to operate properly.
Pressing the "LIGHT" button will turn the light on to full bright-
ness. Holding the button will cause the light to dim slowly –
release the button at the desired brightness to hold the selected
brightness level. Pushing the button again will turn the light off.
The fan may be started by pressing one of the buttons marked "1,"
"2," or "3," for high, medium, or low, respectively. Pressing the
button marked "FAN" will turn the fan off. The
reversing. When this button is pushed the fan will reverse its
direction of rotation.
Wall Mount: A holder is supplied with the transmitter which
can be mounted to a convenient location on a wall. The holder
will help prevent misplacement of your transmitter by providing
a permanent receptacle. See Figure 11A.
If desired, the holder can be mounted directly over the wall
switch.
FIGURE 11A
- -
6
DECORATIVE
ASSEMBLY SCREW
CLEARANCE HOLE
Figure 10C
INDICATOR
LAMP
LIGHT
FAN
FIGURE 11
button is for
HOLDER
©1995 HUNTER FAN CO.™