Table of Contents
Advertisement
3.1.4 Saving New Values and Exiting Set-up Mode
Pressing the Set-up switch once while in Set-up mode stores your set-up changes in the
printer's memory, exits Set-up mode, and automatically returns the printer to print
mode.
NOTE: If you switch off the printer, or if the power is otherwise interrupted before you
press the Set-up switch, no changes are stored in the printer's memory.
3.1.5 Recalling the Factory Defaults
To recall factory default settings, from the Set-up Directory:
Use ← or → to move the cursor to the FACTORY DEFLT setting.
1.
Press ↓.
2.
Refer to the table of factory set-up defaults in Appendix C for details of all factory
defaults.
3.1.6 Optional Emulation Selection Set-up
Optional emulation can be resident EPSON FX-1050 emulation, or emulation provided
by a cartridge installed in the printer. To determine which optional emulation you want
to use, you must define the emulation using optional emulation set-up.
To enter the optional emulation selection set-up:
1.
Set the power switch to OFF (0).
2.
Press and hold simultaneously the SET-UP and PROTOCOL buttons.
3.
Set the power switch to ON (1).
If tractor mode is set, and paper has not already been inserted, the printer loads
paper automatically.
4.
The printer enters Optional Emulation Selection Set-up.
3-8
Advertisement
Table of Contents
