Table of Contents
Advertisement
MAINTENANCE
RECOMMENDED TOOLS
To adjust and service the X-Treme X-140 you will need the following tools:
Allen Wrenches: 3/4/5/6 mm
Wrenches: 8/10/13 mm Open end wrench
Large Adjustable Crescent Wrench
Philips Head Screwdrivers
Oil, Grease or Lubricant
ADJUSTING THE BELT
The belt will come adjusted from the factory. However, it may be necessary to
adjust the belt from time to time. The belt must be well aligned onto the
sprockets in order to avoid uneven wear. This will result in shortened belt life.
How tight should the belt be?
If the belt is skipping or jumping on the sprockets, this is too
loose and may be harmful.
The correct tension is achieved by adjusting the belt from its
loose position to when it becomes lightly tense.
Adjusting the belt too tight may cause the belt to break
To tighten the belt:
Slightly loosen the two axle bolts on both
sides of the rear wheel. Then slowly adjust
the two adjusting screws on each side of the
rear tire until belt reaches the proper tension.
Rotate the rear wheel to make sure the belt is
aligned.
Finally, lock and tighten the rear axle bolts
prior to riding.
Page13
Advertisement
Table of Contents
Troubleshooting
