Fuse Installation; Charging - X-TREME X-140 Owner's Manual

Fuse Installation

Your scooter comes with a 20amp fuse that may need installed if not done so already at
the factory.
Follow the instructions below to properly install the fuse before attempting to use your
scooter.
1. Locate the 20amp glass fuse that came with your scooter.
2. Locate the fuse holder on the front of the scooter frame under the footplate.
(photo above)
3. Remove the fuse holder cap and insert the fuse into the cap first.
4. Then insert fuse/cap into fuse holder and gently tighten. DO NOT OVER
TIGHTEN THE CAP.

Charging

Your scooter comes charged out of the carton. We still recommend charging the unit for
6-8 hours prior to it's first use. We also recommend charging your scooter after each use
and prior to storage.
WARNING: Do not allow your scooter to go into deep discharge, as this will damage the
batteries.
1. Make sure unit is turned off.
2. Open the charging socket located
on the right side of the scooter
frame, under the footplate.
3. Locate your Battery Charger. Find
the charger socket end that has a
single-prong socket and plug it into
the scooter.
4. Next, plug the AC plug into a wall
outlet.
When first plugged in, the charger will have
one red light that will illuminate, indicating
that the charging process has started.
Once the green light on the charger is
illuminated, you may remove the charger
and close the safety cap.
Page10