Carrier Comfort Touch-n-Go Owner's Manual page 23

PROGRAMMING THE THERMOSTAT
Here's how to change the factory−set time periods.
1. Open the door.
2. Press the days button at the bottom of the thermostat. You
will see all days, weekdays and weekends flashing on
the display. You will be changing the time periods accord-
ing to the days of the week. All days is used when the
household's weekday and weekend schedules are the
same.
3. You must select one of these three time−frame options – all
days, weekdays or weekends – by pressing the up or
down button located to the right of the display. You may
also make your selection by pressing the days button
again. (Select all days if your weekday and weekend
schedules are the same.)
4. When you have selected one of the three options (all days,
weekdays, weekends), press the period button at the
bottom of the thermostat. You will see P and a flashing 1
on the screen. This is period 1 (P1), which begins at 6:00
AM.
5. To change the hours in P1, press the start time button at
the bottom of the screen.
21