Removing And Storing Roll Paper - Epson Stylus Photo 890 Basic Manual

8. Windows: Select
your cut paper.
Macintosh: Click the
and click
(Remember, your cut paper size should be at least two inches longer than your
document size to provide the correct margins.)
9. Click
OK
start printing.
10. When you're finished printing, press and release the z roll paper button. The
printer feeds the paper forward 0.8-inch (2 mm) and creates a cut line.
11. Trim the paper at the cut line, and then press and hold the z roll paper button
for at least three seconds to rewind the paper. (You may need to press the z roll
paper button more than once to rewind the paper completely.)
Store your printout in a resealable plastic bag. Keep both printed and unused roll
paper away from high temperatures and humidity and out of direct sunlight.

Removing and Storing Roll Paper

When you finish a print job on roll paper, you can position the paper for another roll
paper print job or remove it from the printer. Follow these steps:
1. Press the z roll paper button. The printer
prints a small line on the roll paper to show you
where to cut it and feeds the paper forward.
2. If you want to print another print job on the
roll paper, press the z roll paper button again;
the paper feeds back into the printer. Then
send the next print job; the paper will move
into the correct loading position before
printing.
70
User Defined
Customize
. The custom size is automatically selected as the Paper Size setting.
OK
In Windows, click the Paper tab to access the Paper Size and Paper
Source settings; on a Macintosh, select Page Setup from the
application's File menu.
(or ). You may need to click
Print
as the Paper Size setting, then input the size of
button, then input the size of your cut paper
(or
OK Print
roll paper button
) on another screen to