Installation Checklist - GE Profile Performance ADVANTIUM SCA2000BAA Service Manual

3. Attach the oven to the top cabinet.
NOTE:
1. You'll need to use a filler block if the cabinet
front hangs below the cabinet bottom shelf.
Cabinet Front
Cabinet Bottom Shelf
Oven Top
2. If your cabinet front hangs more than 2
below the cabinet bottom, you may need to
use longer screws than the ones provided
with this product. The screws provided with
this product (hardware item 3) are self-
aligning, large-head machine screws
" long, with SAE 28 threads per inch. It is
3 1 ?
4
important that you use replacement screws
just long enough to attach the product to
the cabinet. The length can be determined by
measuring the height of the overhang from
the top of the cabinet floor to the bottom of
the overhang and adding one inch to that
length. This will be the length of the
28 threads per inch screws you need.
This is necessar y to allow for clearances
of internal parts of your oven.
Insert 2 self-aligning screws (hardware item 3)
through the outer top cabinet holes. Tighten the
center screw completely and then the outer two
screws to the top of the oven. (While tightening
screws, lift the front side of the oven and push
toward the wall.)
You will also need to use washers
the screws you purchase. This will prevent the
screw heads from pulling through the bottom of
the cabinet when tightening during installation.
Filler Block
Minimum 3/16"
"
3 ?
4
" dia.,
1 ?
4
" SAE
?
1
4
" dia. to fit
3 ?
4
4. Install the grease filters and remove the tape
from the cooktop lamp covers on the bottom
of the oven.
5. Secure the power cord to the cabinet wall, as
desired to keep excess length out of the way.
Use the power cord strap (hardware item 7)
and the black metal screw (hardware item 6).
6. For top exhaust on flat bottomed
cabinets, open the top cabinet and attach the
exhaust adaptor to the oven through the
cabinet bottom.
• Remove and discard the 2 screws for the
blower plate.
• Position the exhaust adaptor (hardware
item 5) over the blower plate, hinge side
toward the back of the oven.
• Attach the exhaust adaptor to the blower
plate using the 2 bronze metal screws
provided (hardware item 6).
Make sure the damper moves freely in the
exhaust adaptor.
Pull the house duct down to connect to the
exhaust adaptor. Tape duct using duct tape.
9

INSTALLATION CHECKLIST

1. Make sure the oven has been installed
according to instructions.
2. Remove all packing material from the oven.
3. Replace house fuse or turn breaker back on.
4. Plug power cord into outlet.
5. Read the Owner's Manual.
6. KEEP INSTALLATION INSTRUCTIONS
FOR THE LOCAL INSPECTOR'S USE.
– 13 –