GE Profile Performance ADVANTIUM SCA2000BAA Service Manual page 43

12. Important Reminder: be sure that you
have removed the oven thermistor wires
from the clip on the side of the upper
blower motor (see step # 10).
OVEN CAVITY
THERMISTOR
Be sure to release the oven cavity thermistor wires
from upper halogen blower retainer clip prior to
removing the halogen blower/lamp assembly
13. Gently lift up on the rear of the upper halo-
gen blower/lamp assembly while swing-
ing the rear of the assembly up and out.
Note: the front (portion closest to the door)
of the blower/lamp assembly slips under
the oven chassis.
Lift up at the rear and pull backwards and up to release
halogen blower/lamp assembly from the front chassis
14. With the upper halogen blower/lamp as-
sembly removed, you can now access the
following component:
• Upper halogen lamp pair
• Upper front & rear thermal cut out
• Oven cavity thermal cut out
• Upper halogen blower assembly
UPPER HALOGEN
BLOWER
Bottom view of upper halogen blower/lamp
assembly (removed from oven)
OVEN CAVITY THERMISTOR REMOVAL
To remove the thermistor follow these steps:
1. Remove the oven from the wall plate.
2. Remove outer case.
3. Remove the complete control panel as-
sembly.
4. Remove the upper halogen blower/lamp
assembly.
5. Remove the thermistor.
MAGNETRON BLOWER REMOVAL
To remove the magnetron blower follow these
steps:
1. Remove the oven from the wall plate.
– 41 –
UPPER HALOGEN
LAMP PAIR
OVEN CAVITY
THERMISTOR