ATEN Master View CS-1004 User Manual page 25

Setting
CLEAR NAME LIST*
RESTORE DEFAULT
VALUES*
* If a password has been set, this setting requires you to supply it in
order to gain access. See the OSD Security section, below, for
details.
CS-1004 / CS-1008 / CS-1016 User Manual
Function
Clears all Port Names from the Name List. You are asked to
confirm before the procedure goes on. Key in Y, then press
[Enter] to confirm. While the names are being cleared, a
message appears on the display to indicate so. After the
names have been cleared, another message appears to
indicate that the procedure is completed successfully.
Note: While this function is in process, make sure that no
other operations are performed on any of the other consoles
Clears all settings from memory, and returns the unit to the
factory default settings (see p.23). You are asked to confirm
before the procedure goes on. Key in Y, then press [Enter]
to confirm. While the settings are being cleared, a message
appears on the display to indicate so. After the settings
have been cleared, another message appears to indicate
that the procedure completed successfully.
2001-06-9
21