ATEN Master View CS-1004 User Manual page 21

! F2 SCAN:
Pressing [F2] initiates Quick View Scanning, in which the OSD
cycles through all the ports that are currently selected in the List view
(see F3, below), and displays each one for the amount of time set
with the Scan Duration setting under the F6 SET function (see p.
19). When you want to stop at a particular location, press the
[Spacebar] to stop scanning.
Note: 1. If the scanning stops on an empty port, or one where the
computer is attached but is powered Off, the monitor
screen will be blank, and the mouse and keyboard will have
no effect. To recover, key in the Hotkey sequence (see
OSD Hotkey Navigation, p.16), for any Port ID that has an
active computer attached.
2. As each computer is accessed and the OSD cycles through
the selected ports, an
display to indicate that it is being accessed under Quick
View Scan Mode.
! F3 LIST:
This function lets you broaden or narrow the scope of which ports the
OSD lists. The submenu choices and their meanings are given in the table below:
Choice
ALL
QVIEW
QVIEW +
POWERED ON
QVIEW + NAME
NAME
POWERED ON
CS-1004 / CS-1008 / CS-1016 User Manual
S appears in front of the Port ID
Meaning
Lists the Port ID numbers and Names (if names have been
specified - see F5), of all the ports on the installation.
Lists only the ports that have been selected for Quick View
scanning (see F4, below).
Lists only the ports that have been selected for Quick View
scanning (see F4, below), and that have their attached
computers Powered On.
Lists only the ports that have been selected for Quick View
scanning (see F4, below), and have been assigned names
(see F5, below).
Lists only the ports that have been assigned names (see F5,
below).
Lists only the ports that have their attached computers
Powered On.
2001-06-9
17