Table of Contents
Advertisement
7.6
Power Connection
Connect the power source to the SOLIVIA gateway (Step 3 in fi gure 4) and check the
SOLIVIA gateway LED. If the setup is correct, the Status LED will be solid green for
approx. 5 seconds. For further information, please refer to Chapter 8.
Verify that your setup is successful by going to the SOLIVIA Monitor web portal at:
http://www.solivia-monitor.com and log in to view your PV system.
3
Figure 4: Connection diagram
WArNINg
Risk of death or heavy injury due to dangerous voltage
► Repairs on defective cables should be done by qualifi ed electri-
► Only recommended and / or commercially available cables
7.7
Installation Feedback
NOTICE
This function works only for SOLIVIA solar inverters of the 4th generation!
Operation and installation manual SOLIVIA Gateway M1 G2
EXT. CONTROL
RESET
RS485
1 2 3 4 5 6 7 8 A B
1
RS485
RS485
cians only!
should be used.
STATUS
GW
LAN
INPUT
5V
2
Internet
11
EN
Advertisement
Table of Contents
