BT Studio 1500 User Manual page 7

3. Insert the 2 x AAA rechargeable batteries supplied,
taking note of the polarity markings inside the battery
compartment, then slide the battery compartment shut.
4. Place the handset on the base to charge. The red charging
light comes on. You should let the batteries charge
continuously for at least 24 hours. The batteries and case
may become warm during charging, this is normal.
5. Once fully charged, plug the telephone line cord into the
telephone wall socket.
BT Studio 1500 multipack users only:
Place each BT Studio 1500 charger within reach of a
mains power wall socket.
If you experience any problems, please call the Helpline on 0870 605 8047 or email bt.helpdesk@suncorptech.com
BT Studio 1500 – Issue 3 – Edition 01 – 18.10.06 – 7875
Getting started
WARNING
Never use non-rechargeable
batteries. Only use the approved
batteries. Using unapproved
batteries will invalidate your
guarantee and may damage the
telephone.
Talk/Standby time
Under ideal conditions, the
handset batteries should give
about 10 hours 30 minutes talk
time or 160 hours standby on a
single charge. (This does not mean
you can unplug the base or leave
it for this length of time without
charge.)
Please note that new NiMH
rechargeable batteries do not reach
full capacity until they have been in
normal use for several days.
See 'Battery performance' on the
following page.
Battery low warning
If the icon is flashing in the
display and you hear a warning
beep every minute during a call,
you will need to recharge your
handset before you can use it.
The charging light will be lit when
the handet is in the base or charger
– even when the batteries are fully
charged.
7