Setting Management Port Ip Addresses Using The Cli - HP StorageWorks 2012i User Manual

Setting Management Port IP Addresses Using the CLI

Note –
the CLI as described in this section.
Ethernet Management ports on controller module A and controller module B are
configured with the following default values:
Management Port IP Address: 10.0.0.2 (controller A), 10.0.0.3 (controller B)
■
IP Subnet Mask: 255.255.255.0
■
Gateway IP Address: 10.0.0.1
■
If the default IP addresses are not compatible with your network, you must set an IP
address for each management port using the command-line interface (CLI)
embedded in each controller module. The CLI enables you to access the system
using RS-232 communication and terminal emulation software.
Use the CLI commands described in the steps below to set the IP address for the
Ethernet management port on each controller module.
Once new IP addresses are set, you can change them as needed using SMU.
Note –
storage system.
1. Refer to the list of IP values you obtained before beginning installation (see
"Installation Checklist" on page 23).
46 HP StorageWorks 2012i Modular Smart Array user guide • March 2008
If you used DHCP to set the IP addresses, you do not have to set them using
Changing IP settings can cause management hosts to lose access to the