Using An Offsite Phone - GE Security Simon XT User Manual

Hide thumbs Also See for Simon XT:
Table of Contents

Advertisement

Using an offsite phone

If enabled by the installer, you can control your Simon XT panel remotely from an offsite phone. The panel
answers a phone call according to the dialing method programmed by your installer.
After a certain combination of rings and pauses, the panel will answer the call with the voice prompt Enter
your code. You must enter the correct code to gain access.
If you are interacting with your panel and the panel hangs up on you, the system is calling in a report to the
central monitoring station or remote phone due to an action by you or someone at the security system site. The
actions listed in Table 6 may be performed from an offsite phone.
Table 6.
Phone controls
Action
Disarm
Subdisarm
Arm doors and windows (Stay)
Arm doors, windows, and
motion sensors (Away)
Check status
Turn light on
Turn light off
Turn all lights on
Turn all lights off
Hang up
2-way voice session
Phone keypresses
1
1
2
3
0
* –<unit_num>.
# –<unit_num>.
* – *
# – #
9
5
Comments
System not already disarmed
Must have used the master code to gain access; system
was disarmed
Press 2 again to activate No delay feature
Press 3 again to activate Latchkey feature
N = 1-8, unit number
N = 1-8, unit number
During session, pressing 1 turns speaker on, 3 turns
microphone on, 9 ends session (hangs up). If no keypresses
are heard by the panel for 90 seconds, it will hang up. After
each keypress, the panel will send a short tone.
Chapter 2
Using the control panel
15

Advertisement

Table of Contents
loading

Table of Contents