How To Replace Pedal Shaft - X-TREME XB-300SLA Owner's Manual

7.) With the wire connector removed from the wires you can now remove the wheel assembly.

How To Replace Pedal Shaft

(Left & Right is based on sitting on bicycle) Keep parts laid out in order for easier installment. Make yourself a drawing if needed and label each part
when removed.
1.) Remove plastic pedal arm cover, that covers center shaft and nut and remove the nut and pull arm off of
sticks out from outer ring to be used later for reassembly)
2.) Turn larger outer ring counterclockwise with punch and remove from inner adjustment ring.
3.) Remove inner bearing adjuster ring and remove inner bearing set.
4.) Perform steps 1-3 for the right side.
5.) Remove center shaft. Before reassembly grease bearings and inner bearing races with high grade grease.
6.) Replace new part with one that was needed replaced and reassemble in reverse order. Install left section first and set the distance recorded from
last part of step 1).
7.) Installing right side adjust inner ring to bearing pressure by turning clockwise until stiffness while rotating the shaft and back off screw 1/8" turn
out counterclockwise. (One rotation equals full turn, and 1/2 turn would be equal to from 12 o'clock to 6 o'clock, a 1/4 would be 15 min position,
and 1/8 position would be equal to 5-7 min on clock.)
ring tight but keeping inner ring on the mark.
8.) Install both arms and nuts and covers.
Use a marker and mark a line from this to frame to keep this position. Install outer lock
shaft. (Make note of distance inner ring
28