GE SCB2000 Technical Service Manual page 9

Route Conduit Through Cutout
Caution: Two people are required to lift the oven
into the opening. Grasp the bottom at front and
rear. Discard styrofoam base. Do not use the
oven handle to lift the oven. Damage will
occur!
1. With the oven in front of the cabinet opening,
insert conduit into cabinet opening.
2. Lift the oven into the opening while continuing
to feed the conduit in the direction of the
installed junction box. Be sure the conduit
does not get pinched between the back of the
oven and the cabinet wall.
Styrofoam
Shipping Base
Secure Oven to Cabinet
1. Slide oven into the cabinet opening.
2. Drill 3/32-in. pilot holes into the cabinet frame
through the 4 mounting holes in the oven's
front frame.
WARNING: Securely fasten oven to cabinet using
the screws provided. Failure to do so could cause
the oven to move or tip during use and result in
personal injury.
3. Secure oven to cabinet with screws supplied.
CAUTION
Connect Electrical
WARNING: Electrical Shock Hazard
• Electrical ground is required on the appliance.
• Do not connect the electrical supply until
appliance is permanently grounded.
• Disconnect power to the junction box before
making the electrical connection.
• This appliance must be grounded to a metallic,
permanent wiring system, or a grounding
connector should be connected to the grounding
terminal or wire lead on the appliance.
• Failure to do so could result in fire, personal
injury, or electrical shock.
GEA00360
– 7 –
Attachment
Screws
Secure Oven To Cabinet
With Screws Provided
GEA00361