Using the camera stand
1 .
Remove the camera from the base .
.
Connect the stand to the base . Carefully use the alignment features to connect the stand easily
to the base.
.
Connect the camera to the stand . Carefully line up the connectors on the stand with the
connectors on the camera.
.
Do not carry the camera by the stand . The base could detach from the stand, and the base
could get damaged if it were to hit the floor. Move the unit by holding on to the base and stand at
the same time.
Camera bottom
Line up connectors
Line up connectors
Base top
QuickCam
Sphere AF
™
Stand top
Correct: Hold base and
stand to move camera.
Stand bottom
Incorrect
Install the Software First
Install the software before plugging in the camera. Many of your camera's extended features,
including autofocus, will not operate properly without the complete software installation.
Connect Your Camera to Your Computer
Wait until you are prompted by the software before
connecting your camera to an available USB port on your
computer.
Insert the installation CD into your
CD-ROM/DVD-ROM drive. Your CD
should start automatically. If it does not,
follow the steps below:
•
Double-click the My computer icon.
Alternatively, click Start My computer.
•
Right-click the CD-ROM/DVD-ROM
drive icon, and then click Autoplay.
QuickCam
Sphere AF
™