I/O System Fan Assembly - HP DL360 Maintenance And Service Manual

Removal and Replacement Procedures

I/O System Fan Assembly

To remove the I/O system fan assembly:
1. Power down the server. Refer to "Powering Down the Server" earlier in this chapter.
2. Remove the server from the rack. Refer to "Removing the Server from the Rack" earlier
in this chapter.
3. Remove the access panel. Refer to "Server Access Panel" earlier in this chapter.
4. Remove the PCI riser board assembly. Refer to "PCI Riser Board Assembly" earlier in
this chapter.
5. Disconnect the fan power cables from the optical device/diskette drive interface
board (1).
6. Disconnect the optical device/diskette drive interface board power cable from the optical
device/diskette drive interface board (2).
7. Remove the optical device/diskette drive interface board power cable from the clip on the
side of the I/O fan assembly (3).
Figure 2-26: Disconnecting cables from the optical device/diskette
drive interface board
2-24
HP ProLiant DL360 Generation 3 Server Maintenance and Service Guide