Scsi Backplane Board - HP DL360 Maintenance And Service Manual

Removal and Replacement Procedures

SCSI Backplane Board

To remove the SCSI backplane board:
1. Power down the server. Refer to "Powering Down the Server" earlier in this chapter.
2. Remove the server from the rack. Refer to "Removing the Server from the Rack" earlier
in this chapter.
3. Remove the access panel. Refer to "Server Access Panel" earlier in this chapter.
4. Remove the optical device/diskette drive interface board. Refer to "Optical
Device/Diskette Drive Interface Board" earlier in this chapter.
5. Lift the SCSI backplane board until it clears the server.
Figure 2-34: Removing the SCSI backplane
Reverse steps 1 through 5 to replace the SCSI backplane.
2-30
HP ProLiant DL360 Generation 3 Server Maintenance and Service Guide