Hunter Ceiling Fans Installation And Operation Manual page 17

Operation, Maintenance, & Cleaning
Turn Power
Battery
Door
Phillips
Head
Screw
To access the battery compartment,
remove the small Phillips head screw
that secures the battery door to the
transmitter assembly. Install one (1)
3-Volt, CR2032 battery (included) into the
transmitter. Clean the battery contacts
and also those of the device prior to
battery installation. The battery should
be installed with the positive (+) side
up. Please contact your local battery
recycling center for proper battery
disposal information.
ON
Note: The remote must be paired
before the fan will operate.
Within 3 minutes of restoring power
to the fan, press both the Fan Off
button and the High button for at
least 4 seconds. Your fan will turn on
low to indicate successful syncing.
If it does not, turn off power to your
fan, wait 1 minute then try again. If
using the transmitter with multiple
fans, repeat this process for each fan.
M3546-01 • 11/13/13 • © Hunter Fan Company
High
Fan Off
The Fan Off button only turns the
fan off. To turn the fan on, press one
of the fan speed buttons.
ooo
oo
o
Quickly press the Light button to
turn the lights off and on.
17
www.HunterFan.com
High
Medium
Low
Fan Off
Light
To install the transmitter cradle,
remove the two screws holding
your switch cover plate. Do not
remove the cover plate. Orient
High
the cradle by lining up the two
Medium mounting holes with those on the
cover plate. Insert and tighten the
Low
screws. Do not over tighten.
This product contains a button battery. If swallowed,
it could cause severe injury or death in just two hours.
Seek medical attention immediately.
1.866.268.1936