Troubleshooting - Hunter Ceiling Fans Installation And Operation Manual

troubleshooting

Problem: Nothing happens; fan does not move.
1. Turn power on, replace fuse, or reset breaker.
2. Loosen canopy, check all connections according to the
w w w w w ir ir ir ir irin in in in ing t g t g th h h h h e f e f e f e f e fa a a a a n n n n n section. g t g t
3. Check the plug connection in the switch housing.
4. Push motor reversing switch firmly up or down to ensure
that the switch is engaged.
5. Remove the shipping bumpers.
Problem: Noisy operation.
1. Tighten the blade bracket screws until snug.
2. Tighten the blade screws until snug.
3. Check to see if the blade is cracked. If so, replace all the
blades.
4. Be sure that the glass is secure.
5. Check and tighten the screws in the switch housing
mounting plate and in the upper and lower switch hous-
ing.
Problem: Excessive wobbling.
1. If your fan wobbles when operating, use the enclosed bal-
ancing kit and instructions to balance the fan.
2. Tighten all blade and/or blade iron screws.
3. Turn power off, support fan very carefully, and check that
the hanger ball is properly seated.
Problem: No functions operate.
1. Replace fuse. Turn ON circuit breaker. Turn ON wall switch.
2. Set transmitter and receiver to same jumper/dip switch
setting.
3. Replace battery with new, alkaline battery.
Problem: Operates only at close range.
1. Replace battery with new, alkaline battery.
Problem: Inconsistent operation.
1. Turn OFF wall switch for 5 seconds, then turn back ON.
2. Change jumper/dip switch settings to a different code in
both transmitter and receiver.
Problem: Fan will not reverse.
1. Select a fan speed button to start fan, then press the re-
verse button.
If you need parts or service assistance, please call 888-830-1326 or
visit us at our WEB site at http://www.hunterfan.com.
Hunter Fan Company
2500 Frisco Avenue
Memphis, Tennessee 38114
© 2003 Hunter Fan Company
11 11 11 11 11
41854-01 11/12/2003