Limiters Crossover (Advanced Tab); Parametric Eq Section - Omnia .11 Installation And Operation Manual

Limiters Crossover Menu (Advanced Tab)

Parametric EQ Section

There are 3 bands of "cut/boost" style parametric EQ available here each with 3 controls: Gain, Freq(uency) and Q.
Parametric EQ (Basic Tab)
Limiters Crossover
The 2 drop-down controls in the Limiters crossover
Advanced tab allow you to modify the crossover
frequency points of the LO (LO to ML) and SL (SL
to LO) limiter bands. The ML to MH, MH to HI and
HI to SH crossover points are not adjustable.
The available LO crossover settings are 320 Hz and
420 Hz.
The available SL crossover settings are 200 Hz, 175
Hz or 110 Hz.
The Gain controls adjust the amount of cut or
boost to be applied over a +/- 12dB range.
The Freq controls adjust the center frequency of
the cut/boost. The Lo frequency range is 30-300
Hz in 5Hz steps, the Mid frequency range is 400 to
1200 Hz in 50Hz steps and the Hi frequency range
is 2000 to 15000 Hz in 100 Hz steps.
The Q controls adjust the bandwidth of the applied
boost/cut relative to the selected center frequency.
A range of 0.1 to 4.0 is available with 0.1 being the
broadest setting (affecting about 6 octaves) and 4.0
being the narrowest setting (affecting about 1/3 of
an octave).
57
(Advanced Tab)