Output Metering; Summary Tab; Detail Tab - Omnia .11 Installation And Operation Manual

Output Metering

Summary Tab

Output Metering Screen (Summary Tab)
The Dorrough Loudness Monitor shows the average loudness and peak level of the audio at the same time.
When you are in the Input menu, the Dorrough meter automatically switches to monitor the Input L+R audio. It
defaults to monitoring the FM channel's Output when you are in any of the processing menus or the Output menu.
Since the output monitor point is after the FM clipper and pre-emphasis, you can also choose to add de-emphasis
using the Dorrough Meter "De-emphasis" control which is located in the Advanced tab of the Output menu.

Detail Tab

There are 5 stereo output meters and a composite meter in the Detail tab:
Output Metering Screen (Detail Tab)
There are 2 stereo output meters below the
Dorrough Loudness Monitor in the Summary
metering tab:
The FM OUTPUT meter shows the real-time peak
output level of the "FM" channel before the output
level controls referenced to the maximum output
level of 0 dBFS. The HD OUTPUT meter similarly
shows the relative peak output of the HD channel.
Normally, these meters will be peaking all the way
up near 0dBFS when the channel is active. The FM
and HD OUTPUT metes can be used as a quick
way to check that the channels are active
internally.
The 5 stereo output meters show the real-time peak
level of the actual outputs after the output level
controls in the Menu screen.
Analog Shows the actual peak output level of the
Left and Right analog XLR output jacks referenced
to a "0" peak level of +22 dBu.
AES/EBU
1 Shows the actual peak output level of the AES 1
XLR output jack referenced to 0 dBFS.
2 Shows the actual peak output level of the AES 2
XLR output jack referenced to 0 dBFS.
32