Table of Contents
Advertisement
3
1 Release the buckle, 2 bundle the cable with the belt, 3
then close the buckle again.
4
Adjust the length by pulling down on the end of the belt.
AC Power Supply (Standalone
Operation)
Prepare an AC power supply when using the camera in standalone
operation mode (without a CCU).
For safety, use only the Sony AC adaptor listed below.
• AC adaptor: AC-DN10
If using the DC IN connector
Connect the AC-DN10 AC adaptor to the DC IN output connector
on the camera using an optional DC power cord.
If attaching the AC adaptor
Remove the rear cover and attach the AC adaptor to the camera.
Removing the rear cover
1 Hold the release button on the camera in, and 2 pull the rear
cover up.
Attaching the AC adaptor
Attach an optional AC-DN10 AC adaptor to the camera, then
connect to the AC power supply.
The AC-DN10 can supply up to 100 W of power.
To attach the rear cover
Align the guide on the inner side of the rear cover with the camera
adaptor mount, and insert the cover.
15
To AC outlet
Rear cover
Advertisement
Table of Contents
