Parameter Settings - Sony Owner’s Guide Operational Manual

Example

Parameter Settings

Settings on the camera
Set the communication parameters using the NETWORK menu.
page Item
<IP ADDR SET> HOST IP ADDRESS
SUBNET MASK
DEFAULT GATEWAY
<ETHER I/F CONF> AUTO NEGOTIATION
CONNECT SPEED
DUPLEX MODE
<700PTP SETTING> NS MODE
CAMERA NO.
MASTER IP ADDRESS
1) While the connection may be steady with the ON setting, the performances
are improved with an OFF setting for the collateral condition.
98
Using the MSU-900/950
REMOTE
REMOTE
PANEL STANDARD MONITOR TEST BARS CLOSE VTR
ACTIVE START/STOP
MEMORY 5600K AUTO SKIN BLACK KNEE
STICK
KNEE DETAIL GAMMA SATURATION
AWB ABB
WHITE
FUNCTION
ABS
BLACK
MAINTE
NANCE
SCENE
AUTO IRIS/MB
ACTIVE MASTER
IRIS
BLACK
PAINT EXT
IRIS
ALARM
REMOTE CONTROL UNIT
RM-B750
REMOTE
REMOTE
PANEL STANDARD MONITOR TEST BARS CLOSE VTR
ACTIVE START/STOP
MEMORY
STICK 5600K AUTO SKIN BLACK KNEE
KNEE DETAIL GAMMA SATURATION
AWB ABB
WHITE
FUNCTION
ABS
BLACK
MAINTE
NANCE
SCENE
AUTO IRIS/MB
IRIS ACTIVE MASTER
BLACK
PAINT EXT
IRIS
ALARM
REMOTE CONTROL UNIT
RM-B750
REMOTE
REMOTE
PANEL STANDARD MONITOR TEST BARS CLOSE VTR
ACTIVE START/STOP
MEMORY
5600K AUTO SKIN BLACK KNEE
STICK
KNEE DETAIL GAMMA SATURATION
AWB ABB
WHITE
FUNCTION
ABS
BLACK
MAINTE
NANCE
SCENE
AUTO IRIS/MB
ACTIVE MASTER
IRIS
BLACK
PAINT EXT
IRIS
ALARM
REMOTE CONTROL UNIT
RM-B750
Setting in Bridge mode
IP address specific to the camera
Value corresponding to the network
environments in use
Value corresponding to the network
environments in use
1)
ON or OFF
No setting required if AUTO
NEGOTIATION is set to ON. For the
OFF setting, select 10M or 100M.
Select HALF or FULL.
BRIDGE
No setting required
Set the IP address of the MSU-900/
950 connected.
HUB
MSU-900/950
Setting in Multi mode
T
T
T
T
T
T
MCS
ID number specific to the camera
Set the IP address of the master
MSU-900/950.