Selecting The Interface Type; Interface Selection; Configuring The Interface - Datalogic Gryphon GBT4100 Quick Reference Manual

Selecting the Interface Type

Selecting the Interface Type
Upon completing the physical connection between the reader and
its host, proceed directly to
formation and programming for the interface type the reader is
connected to (for example: RS-232, Keyboard Wedge, USB, etc.)
and scan the appropriate barcode to select your system's correct
interface type.

Interface Selection

Each reader model will support one of the following sets of host
interfaces:
General Purpose Models:
board Wedge, Wand.
Retail Point of Sale Models :
46XX.
Information and programming options for each interface type are
provided in this section.

Configuring the Interface

Scan the programming barcode which selects the appropriate in-
terface type matching the system the reader will be connected to.
If you need to customize additional settings and features associat-
ed with that interface, proceed to the corresponding chapter in
the Gryphon™ I PRG.
NOTE
18
Interface Selection on page 18
RS-232, RS-232 OPOS, USB, Key-
RS-232, RS-232 OPOS, USB, IBM
Unlike some other programming features and options,
interface selections require that you scan only one pro-
gramming barcode label. DO NOT scan an ENTER/EXIT bar-
code prior to scanning an interface selection barcode.
Some interfaces require the scanner to start in the dis-
abled state when powered up. If additional scanner con-
figuration is desired while in this state, pull the trigger
and hold for 5 seconds. The scanner will change to a state
that allows programming with barcodes.
for in-
Gryphon™ I GBT4100