Installing The Board - HP HEWLET VECTRA VA 6/XXX User Manual

Installing the Board

1 Switch off the display and computer, and disconnect the power
supply cables and any telecommunications cables. Remove the
computer's cover.
2 Remove the air flow guide (refer to "Removing the Air Flow Guide",
on page 14).
3 Find a free accessory board slot with the correct type of connector
socket (PCI or ISA). Some boards may have preferred locations, in
which case special installation instructions should be detailed in
their manuals.
4 Unscrew and remove the accessory board slot cover. Store it in a safe
place. If the slot cover is tight, loosen the screws on the adjacent
slots.
Step 4: Unscrew and
remove the accessory
board slot cover.
5 Hold the board vertically with the connector towards the socket.
Slide it into the free slot from which you have just removed the slot
cover. Do not bend the board.
2 How to Install Accessories In Your PC
Installing Accessory Boards
Step 5: Slide the board into a
free slot.
English 27