Regency MX Excel Owner's Manual page 8

I
NSTALLING THE
1. Carefully support fan body (motor) in its styrofoam packing with the mounting collar (where the wires come out)
facing upward. Select the 3˝ or 6˝ (or optional extension) downrod you wish to use.
2. Remove ball from the 3" or 6˝ downrod by loosening set screw in the side of the ball. Slide ball down and remove
ball pin; remove ball.
3. Feed the wires from top of fan through end of the downrod of choice and set end of downrod into mounting collar
so the hole in the downrod lines up with the hole in the side of the mounting collar.
4. Insert downrod pin through holes in mounting collar and downrod; slip cotter pin through small hole in end of
downrod pin to hold downrod in place.
5. Tighten security screws against downrod using a large flat blade screwdriver to ensure a tight fit against downrod.
Tighten nuts against mounting collar.
NOTE: Fan has 6 feet of hook-up wire in
case you are using a long extension down-
rod. Wires can be cut so only 8 inches or
so extend beyond the top of the downrod
to make the electrical connections easier
and safer.
6. Feed wires through collar cover and
slide collar cover down the downrod to
top of fan.
7. Feed wires through canopy and slide
canopy over downrod to lay on top of
collar cover. It will be attached to
ceiling later.
8. Feed wires through ball and slide ball
over downrod, past hole in the top end
of the downrod. Insert ball pin
(removed in step 2), slide ball up, and
tighten set screw to secure ball in place.
F D
AN WITH A OWNROD
6
Fig. 2