Planet ICA-3350V User Manual page 12

Descriptions for I/O cable set:
Interface
Connects to your local area network by Ethernet cable
LAN LED (green color)
RJ45 LAN
This LED will be flashing while network accessing via Ethernet
socket
Power LED (orange color)
This LED is used to indicate whether DC power is on or not
DC power input, connect to AC power adapter
Note:
DC-in Jack
adapter included in package
RS-485：Connect to a local keyboard controller
DI/ DO: Connect to sensor in and alarm out devices
Cable for I/O connectors:
Name
12VDC
RS-485 &
DI
digital I/O
GND
DO
485+
485-
Connect a microphone to the network camera
MIC in
(Audio
in)
Connect a loud speaker to the network camera. This function is for voice alerting
Audio out
and two-way audio
The Network Camera also provides composite video output. The video output
Video out
function is only for easy installation to check view angle and focus. The output is
(BNC
not a Mega-pixel resolution. Furthermore, only "720p Mode" supports this
connec
function. "2 Mega Mode" does not support it. Please refer to Setting \ Video \
tor)
Common chapter
This button is used to restore the all factory default settings. Sometimes
restarting the device will make the system back to a normal state. However, if
the system still got problems after restart, user can restore the factory default
settings and install it again.
Restore the device:
1. While the Camera is ready and then press the button down continuously
Reset
2. Hold the button at least 5 seconds and release it. Then the device has been
restored to default settings and reboot again
Note: Restoring the factory default setting will lose the all previous settings
included IP address forever. User needs to run the IPWizard II program to
search the device and configure it to let the device work properly again
that supply the power to the Network Camera with the power
Number
1 DC 12V (50mA maximum)
2 Digital signal input
3 GND
4 Digital signal output
5 RS485 data +
6 RS485 data -
Description
Function
11