Hardware Installation - Planet ICA-3350V User Manual

2.3 Hardware Installation

1. Fix IR camera to desired location with stand
Use three screws to fix the Network Camera onto the ceiling or wall. You could also put
the Network Camera on the table directly.
2. Connect an Ethernet cable
Connect Ethernet cable to IP camera's Ethernet port.
If there has an IEEE802.3af PoE switch in your network, you can connect the
NOTE:
camera LAN cable to this PoE switch to obtain power. The power adapter is
unnecessary when Internet camera is connected to a PoE switch.
3. Connect RS485 D+ and D- (if you need to control PT scanner)
4. Attach the power supply
Plug in power adapter and connect to power source. After power on, the camera will start to
operate.
1. Only use the power adapter supplied with Internet camera Otherwise, the
NOTE:
product may be damaged.
2. The power adapter is unnecessary when Internet camera is connected to a
PoE switch. Otherwise, the product may be damaged when Internet camera
is connected to a PoE switch and power adapter simultaneously.
13
Fixed it by
Screws