Lucent Technologies 6408+ User Manual page 22

buttons in the right column begin with i and then go through p (on the 6416D+
and 6416D+M) and through x (on the 6424D+ and 6424D+M). When the
a=
display shows
appearance button. The next button down would be shown as
so on.
When you dial an extension, that number is shown and then replaced by the
called party's name and extension. When a call is received from another
extension, the caller's name is shown; when a call is received from outside,
"OUTSIDE CALL" or a trunk identifier is shown.
The display remains in Normal (call-handling) Mode until you activate one of
the other display or softkey features. After using any of these features, return
to Normal Mode by pressing the Exit button.
Call Timer and Timer
The Call Timer and the Timer features are used to measure elapsed
time on a call.
However, the Call Timer feature can be used ONLY if your telephone
is connected to a DEFINITY ECS Release 6.3 or later. This feature,
once activated, measures elapsed time automatically on all calls until
you turn off the Call Timer feature.
The Timer feature must be turned on for each individual call you wish
to time. At the end of the call, you must immediately turn off the feature.
This feature can be used with any DEFINITY switch release.
Check with your system manager to see if you can use either of these
features.
To use the Call Timer feature to measure elapsed time on telephone
calls
1. Press the Menu button and then press the softkey below CTime
or, if CTime is not available on your display, press the
button (if administered).
The Call Timer will measure elapsed time automatically on all calls
until you turn off the Call Timer feature.
2. When you want to turn off the Call Timer feature, press the Menu
button and press the softkey below CTime
or, if you have activated this feature with
Call Timer
To use the Timer feature to measure elapsed time on an individual
telephone call
1. Press the Menu button and then press the softkey below Timer (which
exits you from softkey mode)
or, if Timer is not available on your display, press the
(if administered).
2. To stop the timer and clear the display, press the Menu button and then
press the softkey below Timer again
or, if Timer is not available on your display, press
, it represents call information for the first call
button.
Call Timer
18
b=
, and
Call Timer
,
press the
button
Timer
again.
Timer