Assembling The Function Keymat; Main Flex And Ui Flex Assembly - Nokia 6210 Navigator Service Manual

Hide thumbs Also See for 6210 Navigator:

Table of Contents

11.2 Assembling the Function Keymat

1. Start from the hooks on the bottom of the keymat and continue by pressing the keymat in place.

Note! Do not damage the guiding pins.

2. Check that keymat edges are symmetrically in place.

3. After A-cover assembly, press the keymat for a few seconds (minimum of 3 seconds) to activate the glue

on the domesheet.

Note! For example, when doing LCD and A-cover re-work: Because adhesive has been used, there is no

need to remove the function keyboard unnecessarily.

If the function keyboard or domesheet is broken, remove the A-cover first!

Note!

Adhesive on the domesheet must be renewed before Alpha and Function keymat assembly.

•

Always remove the old adhesives carefully as otherwise the keyboard may not function properly.

•

Alignment of the keymat adhesives should be done according to the holes on the slide modules!

Check visually and test functionality.

•

Carefully remove all of the old adhesives from the slide and flex modules before the assembly of a new one.

Note! Align the new flex with the holes on the slidemodule.

Confidential

6210 Navigator RM-367, RM-386, RM-408, RM-419

Service Manual Level 1&2

ISSUE 1

Table of Contents