Page of 3

Nokia 6210 Quick Manual

Nokia 6210: connection guide.
Hide thumbs
   
A Quick Guide to Using the Nokia 6210 with an Infrared data connection in
SETTING UP A NEW CONNECTION
1. Go to the Start menu and select Settings
2. Select Modem
3. You should now have a list of available connections; just click on the New Connection... option.
4. Now complete the settings as shown in the figures below:
Figure 1. Select a modem and
check the Baud Rate. After that
tap Advanced...NOTE! When using the Flow Control selected is Software. Tap OK
HSCSD Baud Rate should be set
higher.
Figure 4. Uncheck the Wait for
Dial tone before dialing check box
and tap Finish. *
Copyright ã 2000. Nokia
All rights reserved.
.
Nokia 6210
12.10.00
a PocketPC device
Figure 2. Check Connection
preferences. Especially that
on upper right corner and then tap
Next
Figure 5. Now go to Dialing leaflet Figure 6. In some cases you may need
and go to Dialing Patterns...
Figure 3. Type in the ISP's phone
number and then tap Next.
to edit these to get the phone number
right when dialing.
1(3)

   Related Manuals for Nokia 6210

   Summary of Contents for Nokia 6210

  • Page 1

    A Quick Guide to Using the Nokia 6210 with an Infrared data connection in SETTING UP A NEW CONNECTION 1. Go to the Start menu and select Settings 2. Select Modem 3. You should now have a list of available connections; just click on the New Connection… option.

  • Page 2

    5. Figures 9 and 10 shows the Status screens of the connection Figure 7. Figure 8. Figure 9. Figure 10. 6. You should now be connected to your ISP, so just start your Internet Explorer or Inbox. Copyright. ã 2000. Nokia Mobile Phones 2(3)

  • Page 3

    The contents of this document are provided "as is". Except as required by the applicable law, no warranty of any kind, either express or implied, is made in relation to the accuracy, reliability or content of the document. Nokia reserves the right to revise the document or withdraw it at any time without prior notice.

Comments to this Manuals

Symbols: 0
Latest comments: