Packing List; Information You Will Need About Your Lan Or Computer - D-Link DSL-G604T User Manual

LAN Subnet Mask for the
DSL-302T

Information you will need about your LAN or computer:

Ethernet NIC
DHCP Client status
It is recommended that your collect and record this information here, or in some other secure place, in case you
have to re-configure your ADSL connection in the future.
Once you have the above information, you are ready to setup and configure your DSL-G604T ADSL Router.
The Modem may be reset to its factory default settings by performing a Restore settings
operation within the management interface (see System Commands). If you cannot
gain access to the management interface, you may opt to use the Reset button on the
Note
rear panel of the device (see Error! Reference source not found. below).

Packing List

Open the shipping carton and carefully remove all items. Make sure that you have the items listed here.
1. One DSL-G604T 802.11b Wireless ADSL Ethernet Router
2. One CD-ROM containing the User's Guide
3. One twisted-pair telephone cable used for ADSL connection
4. One straight-through Ethernet cable
5. One AC power adapter suitable for your electric service
6. One Quick Installation Guide
DSL-G604T DSL Router User's Guide
This is the subnet mask used by the DSL-G604T, and will be
used throughout your LAN. The default subnet mask is
255.0.0.0. This can be changed later.
If your computer has an Ethernet NIC, you can connect the
DSL-302T to this Ethernet port using an Ethernet cable.
You can also use the Ethernet port on the DSL-302T to
connect to other Ethernet devices, such as a Wireless
Access Point.
Your DSL-302T ADSL Modem is configured, by default, to
be a DHCP server. This means that it can assign an IP
address, subnet mask, and a default gateway address to
computers on your LAN. The default range of IP addresses
the DSL-302T will assign are from 192.168.1.2 to
192.168.1.254. Your computer (or computers) needs to be
configured to Obtain an IP address automatically (that is,
they need to be configured as DHCP clients.)
xvi
Record info here