Facility Safety Precautions
It is the sole responsibility of the user/owner or facility operator to ensure that regular maintenance is
performed.
•
Enforce all user and safety precautions.
•
Read and understand the Owner's Manual completely before assembling, servicing or using unit.
•
Verify all users are properly trained on using the equipment.
•
Do not use unit outdoors.
•
Verify that each unit is setup, leveled and operated on a solid level surface. Do not install
equipment on an uneven surface. Do not operate in recessed areas or on plush carpet.
•
Verify there is enough room for safe access and operation of unit.
•
Instruct all users on how to clip the e-stop clip onto their clothing and carefully test it prior to using
the treadmill.
•
Instruct all users to use caution when mounting and dismounting the treadmill.
•
Use a dedicated line when operating the treadmill. A dedicated line requires one circuit breaker per
unit.
•
Connect the treadmill to a properly grounded outlet only.
•
DO NOT operate electrically powered treadmills in damp or wet locations.
•
Keep the running belt clean and dry at all times.
•
DO NOT leave the treadmill unattended when plugged in and running. NOTE: Before leaving the
treadmill unattended, always wait until the treadmill comes to a complete stop and is level. Then,
turn all controls to the STOP or OFF position and remove the plug from the outlet. Remove the
e-stop key from the treadmill.
•
Immobilize the treadmill (when not in use) by removing the e-stop key.
•
Inspect the treadmill for worn or loose components before each use. Do not use until worn or
damaged parts are replaced.
•
Stop and place the treadmill at 0 degrees incline (level) after each use.
•
Maintain and replace worn parts regularly. Refer to "Preventive Maintenance" section of Owner's
Manual.
•
DO NOT operate the treadmill if: (1) the cord is damaged; (2) the treadmill is not working properly
or (3) if the treadmill has been dropped or damaged. Seek service from a qualified technician.
•
DO NOT place the cord near heated surfaces or sharp edges.
•
DO NOT use the treadmill outdoors.
•
DO NOT operate the treadmill around or where aerosol (spray) or where oxygen products are
being used.
•
Ensure all users wear proper footwear on or around all Cybex equipment.
•
Disconnect power before servicing.
DO NOT attempt repairs, electrical or mechanical. Seek qualified repair personnel when servicing.
•
If you live in the USA, contact Cybex Customer Service at 888-462-9239. If you live outside the
USA, contact Cybex Customer Service at 508-533-4300.
•
Use Cybex factory parts when replacing parts on the treadmill.
•
DO NOT modify the treadmill in any way.
•
DO NOT use attachments unless recommended for the treadmill by Cybex.
Cybex 770T-CT Treadmill Owner's Manual
9
Need help?
Do you have a question about the 770T-CT and is the answer not in the manual?